Marmitek MultiMedia Remote Manual do Utilizador descarregar pdf (Página 12)

Programming the X10 address and the various options.

The chart below shows the various possibilities to program the

MicroModule LWM1P.

Factory defaults Programmable Command Light blinks

Address A1 Address A2 .. P16 2x Address 2x

Doesn’t respond to Responds to 2x All Lights On 6x

“All Lights On” “All lights On”

Doesn’t respond to Responds to 2x All Off 8x

“All Off” “All Off”

Connected switch is a Connected switch is a 2x Bright 12x

2-way momentary switch 1-way momentary switch

For programming the Haibrain X10 address a

nd options you will

be able to use any Haibrain X10 controller or remote control,

apart from the CM11 computer interface.

For the following explanation we used a Haibrain 8-in-1 remote

control to program the preferred settings (when you use an RF

remote control like the Haibrain 8-in-1, then a TM13 Plug-in

Transceiver is required to convert the RF signals to the X10

commands through the power line).

Sample 1. Program the Haibrain X10 address E4:

• Setup your remote control (see manual 8-in-1) and the TM13

transceiver to house code E.

• Start with the MicroModule in setup mode.

•

Press the Haibrain X10 button (marked with the symbol of a

house) of the 8-in-1 remote control and then press button 4.

• Press the “ON” button 2x (= channel+).

• The MicroModule responds by blinking the LED twice.

• The address E4 is programmed.

• If you wish to program more options, you have to make sure

the module remains in setup mode.

Sample 2. Program the function “All Units Off”.

•

Make sure you program the required Haibra

in X10 address

first!! (e.g. E4).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Sem comentários

Marmitek MultiMedia Remote Manual do Utilizador Página 12