Marmitek MultiMedia Remote Manual do Utilizador

AWM2P AWM2P™MICROMODULE20262 / 20080521 • AWM2PTM © ALL RIGHTS RESERVED MARMITEK®USER MANUAL 3GEBRUIKSAANWIJZING 73

10 © MARMITEKFigure 4• Install the wall switch at its original place after the MicroModule is programmed.Please note: due to heat generation, apply n

11AWM2P™ENGLISHFigure 5Activate or exit the setup mode.Programming the X-10 address and the various optionsThe chart below shows the various pos

12 © MARMITEKprogram the preferred settings (When you use an RF remote control like the Marmitek 8-in-1, then a TM13 Plug-in Transceiver is required t

13AWM2P™ENGLISHWhen you wish to program the module with the help of a remote control in combination with an IRRF7243, you need to follow a s

14 © MARMITEKwhen the range of your remotes is not sufficient. The TM13 is using so called collision detection to prevent signals to be disturbed when

2 © MARMITEK1ENGLISH1. Phase clamp (230V)2. Load clamp3. Neutral clamps4. Indicator light (LED)5. Set up button6. Wire connections to wall switc

3AWM2P™ENGLISHMARMITEK MICROMODULE AWM2PMarmitek X-10 transmitter for 2 addresses with a built-in appliance module.SAFETY WARNINGS• The wiring

4 © MARMITEK 1. ModulesThese components will receive Marmitek X-10 signals and will switch or dim the attached lamp or appliance. 2. ControllersThes

5AWM2P™ENGLISHcouple them with the use of a CAT 3000 active 3 phase coupler/repeater (Art.No. 09304) and it is required if wall outlets and

6 © MARMITEKMarmitek X-10 signals are disturbed by e.g. baby phones which are in TALK mode (continuous transmission). When these kind of signa

7AWM2P™ENGLISH• The AWM2P supports two way Marmitek X-10 communication.• Both normal switches (on-off) and Momentary switches can be connected to th

8 © MARMITEKWhite: Input 2, second addressWhen the red wire is connected to the phase wire, the programmed “address +1” will be transmitted (e.g. when

9AWM2P™ENGLISHFigure 2• Connect the phase, neutralize and load wire to the terminals of the MicroModule AWM2P.• Connect the thin wires of the built-